TY  - JOUR
AU  - Juloski, Jelena
AU  - Fadda, Giovanni M.
AU  - Radović, Ivana
AU  - Chieffi, Nicoletta
AU  - Vulićević, Zoran
AU  - Aragoneses, Juan M.
AU  - Ferrari, Marco
PY  - 2013
UR  - https://smile.stomf.bg.ac.rs/handle/123456789/1842
AB  - The adhesion of fiber posts luted with simplified adhesive systems has been a matter of great interest over the past years. The aim of this study was to assess the post retentive potential of experimental self-adhesive resin cement (EXP) when used alone and in combination with a self-etch adhesive. Fiber posts were placed in endodontically treated teeth and divided into four groups (n = 6) according the luting material, as follows: group 1 (EXP alone); group 2 (EXP used with self-etch adhesive); group 3 (marketed dual-cured cement used with self-etch adhesive); and group 4 (marketed self-adhesive cement). The push-out test was used to assess the retentive strength of fiber posts (expressed in MPa), and specimens were analyzed under a stereomicroscope to determine failure mode. The adhesive interface between the cement and root canal dentin for each group was evaluated using scanning electron microscopy. The post retentive potential of group 1 (EXP) (7.48 +/- 4.35 MPa) was comparable with that of marketed cements from group 4 (6.79 +/- 3.68 MPa) and group 3 (8.77 +/- 4.58 MPa). When EXP was used in combination with self-etch adhesive (group 2), significantly higher push-out bond-strength values were measured (15.87 +/- 4.68 MPa) compared with the other groups.
PB  - Wiley-Blackwell, Hoboken
T2  - European Journal of Oral Sciences
T1  - Push-out bond strength of an experimental self-adhesive resin cement
VL  - 121
IS  - 1
SP  - 50
EP  - 56
DO  - 10.1111/eos.12005
ER  - 

@article{
author = "Juloski, Jelena and Fadda, Giovanni M. and Radović, Ivana and Chieffi, Nicoletta and Vulićević, Zoran and Aragoneses, Juan M. and Ferrari, Marco",
year = "2013",
abstract = "The adhesion of fiber posts luted with simplified adhesive systems has been a matter of great interest over the past years. The aim of this study was to assess the post retentive potential of experimental self-adhesive resin cement (EXP) when used alone and in combination with a self-etch adhesive. Fiber posts were placed in endodontically treated teeth and divided into four groups (n = 6) according the luting material, as follows: group 1 (EXP alone); group 2 (EXP used with self-etch adhesive); group 3 (marketed dual-cured cement used with self-etch adhesive); and group 4 (marketed self-adhesive cement). The push-out test was used to assess the retentive strength of fiber posts (expressed in MPa), and specimens were analyzed under a stereomicroscope to determine failure mode. The adhesive interface between the cement and root canal dentin for each group was evaluated using scanning electron microscopy. The post retentive potential of group 1 (EXP) (7.48 +/- 4.35 MPa) was comparable with that of marketed cements from group 4 (6.79 +/- 3.68 MPa) and group 3 (8.77 +/- 4.58 MPa). When EXP was used in combination with self-etch adhesive (group 2), significantly higher push-out bond-strength values were measured (15.87 +/- 4.68 MPa) compared with the other groups.",
publisher = "Wiley-Blackwell, Hoboken",
journal = "European Journal of Oral Sciences",
title = "Push-out bond strength of an experimental self-adhesive resin cement",
volume = "121",
number = "1",
pages = "50-56",
doi = "10.1111/eos.12005"
}

Juloski, J., Fadda, G. M., Radović, I., Chieffi, N., Vulićević, Z., Aragoneses, J. M.,& Ferrari, M.. (2013). Push-out bond strength of an experimental self-adhesive resin cement. in European Journal of Oral Sciences
Wiley-Blackwell, Hoboken., 121(1), 50-56.
https://doi.org/10.1111/eos.12005

Juloski J, Fadda GM, Radović I, Chieffi N, Vulićević Z, Aragoneses JM, Ferrari M. Push-out bond strength of an experimental self-adhesive resin cement. in European Journal of Oral Sciences. 2013;121(1):50-56.
doi:10.1111/eos.12005 .

Juloski, Jelena, Fadda, Giovanni M., Radović, Ivana, Chieffi, Nicoletta, Vulićević, Zoran, Aragoneses, Juan M., Ferrari, Marco, "Push-out bond strength of an experimental self-adhesive resin cement" in European Journal of Oral Sciences, 121, no. 1 (2013):50-56,
https://doi.org/10.1111/eos.12005 . .

TY  - JOUR
AU  - Juloski, Jelena
AU  - Carrabba, Michele
AU  - Manuel Aragoneses, Juan
AU  - Forner, Leopoldo
AU  - Vichi, Alessandro
AU  - Ferrari, Marco
PY  - 2013
UR  - https://smile.stomf.bg.ac.rs/handle/123456789/1820
AB  - Purpose: To evaluate the microleakage of Class II cavities restored with experimental low-shrinking resin composites proposed for bulk filling and to measure their microtensile bond strength (mu TBS) to dentin and compare to those of previously marketed low-shrinkage composites. Methods: Class II cavities (7 mm occluso-gingival height, 2 mm mesio-distal depth of the box, 4 mm occlusal depth, 4 mm bucco-lingual width) were prepared in 50 molars and randomly divided into five groups (n=10), according to the material: SureFil SDR flow (SDR), Filtek Silorane (FS) and experimental materials (G-aenial Flo bulk fill, GF; G-aenial Universal Flo bulk fill, GUF; GC Kalore bulk fill, GK). Microleakage was separately assessed at enamel and dentin margins by scoring the depth of silver-nitrate penetration. Twenty teeth divided into five groups (n= 4) were selected for mu TBS testing. The same materials as for microleakage assessment were placed in bulk to mid-coronal dentin. Microtensile beams were loaded in tension, and mu TBS at failure was calculated in MPa. Microleakage and mu TBS data were analyzed by ANOVA on ranks, followed Dunn's post hoc test (P lt  0.05). Results: Microleakage was not observed at the enamel interface in any of the groups. At the dentin interface, SDR recorded significantly higher microleakage than the other materials. mu TBS of GF, GUF and GK did not differ among each other (33 +/- 12 MPa, 31 +/- 11 MPa, 30 +/- 9 MPa, respectively), while SDR (63 +/- 17 MPa) and FS (55 +/- 17MPa) achieved significantly higher mu TBS values. No direct association between the sealing properties and the bond strength values was observed.
T2  - American Journal of Dentistry
T1  - Microleakage of Class II restorations and microtensile bond strength to dentin of low-shrinkage composites
VL  - 26
IS  - 5
SP  - 271
EP  - 277
UR  - https://hdl.handle.net/21.15107/rcub_smile_1820
ER  - 

@article{
author = "Juloski, Jelena and Carrabba, Michele and Manuel Aragoneses, Juan and Forner, Leopoldo and Vichi, Alessandro and Ferrari, Marco",
year = "2013",
abstract = "Purpose: To evaluate the microleakage of Class II cavities restored with experimental low-shrinking resin composites proposed for bulk filling and to measure their microtensile bond strength (mu TBS) to dentin and compare to those of previously marketed low-shrinkage composites. Methods: Class II cavities (7 mm occluso-gingival height, 2 mm mesio-distal depth of the box, 4 mm occlusal depth, 4 mm bucco-lingual width) were prepared in 50 molars and randomly divided into five groups (n=10), according to the material: SureFil SDR flow (SDR), Filtek Silorane (FS) and experimental materials (G-aenial Flo bulk fill, GF; G-aenial Universal Flo bulk fill, GUF; GC Kalore bulk fill, GK). Microleakage was separately assessed at enamel and dentin margins by scoring the depth of silver-nitrate penetration. Twenty teeth divided into five groups (n= 4) were selected for mu TBS testing. The same materials as for microleakage assessment were placed in bulk to mid-coronal dentin. Microtensile beams were loaded in tension, and mu TBS at failure was calculated in MPa. Microleakage and mu TBS data were analyzed by ANOVA on ranks, followed Dunn's post hoc test (P lt  0.05). Results: Microleakage was not observed at the enamel interface in any of the groups. At the dentin interface, SDR recorded significantly higher microleakage than the other materials. mu TBS of GF, GUF and GK did not differ among each other (33 +/- 12 MPa, 31 +/- 11 MPa, 30 +/- 9 MPa, respectively), while SDR (63 +/- 17 MPa) and FS (55 +/- 17MPa) achieved significantly higher mu TBS values. No direct association between the sealing properties and the bond strength values was observed.",
journal = "American Journal of Dentistry",
title = "Microleakage of Class II restorations and microtensile bond strength to dentin of low-shrinkage composites",
volume = "26",
number = "5",
pages = "271-277",
url = "https://hdl.handle.net/21.15107/rcub_smile_1820"
}

Juloski, J., Carrabba, M., Manuel Aragoneses, J., Forner, L., Vichi, A.,& Ferrari, M.. (2013). Microleakage of Class II restorations and microtensile bond strength to dentin of low-shrinkage composites. in American Journal of Dentistry, 26(5), 271-277.
https://hdl.handle.net/21.15107/rcub_smile_1820

Juloski J, Carrabba M, Manuel Aragoneses J, Forner L, Vichi A, Ferrari M. Microleakage of Class II restorations and microtensile bond strength to dentin of low-shrinkage composites. in American Journal of Dentistry. 2013;26(5):271-277.
https://hdl.handle.net/21.15107/rcub_smile_1820 .

Juloski, Jelena, Carrabba, Michele, Manuel Aragoneses, Juan, Forner, Leopoldo, Vichi, Alessandro, Ferrari, Marco, "Microleakage of Class II restorations and microtensile bond strength to dentin of low-shrinkage composites" in American Journal of Dentistry, 26, no. 5 (2013):271-277,
https://hdl.handle.net/21.15107/rcub_smile_1820 .